enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Self-framing metal buildings - Wikipedia

   en.wikipedia.org/wiki/Self-Framing_Metal_Buildings

   Exterior roof panels are usually a single continuous length from eave to ridge line for gable style buildings or from low eave to high eave on single slope or shed style buildings. Many manufacturers provide minimum 24 gauge (nominal: 0.0239 inch; 0.61 mm) thick sheet steel in self-framing roof designs.

3. Roof seamer - Wikipedia

   en.wikipedia.org/wiki/Roof_seamer

   A roof seamer is a development that replaced a manual process and hand tools of the past. A hammer and small anvil were tools that were used for hemming and seaming roof panels together at the edge where they meet with the next roof panel in sequence. In 1976, a German immigrant and inventor, Ewald Stellrecht, [1] helped develop an early ...

4. Metal roof - Wikipedia

   en.wikipedia.org/wiki/Metal_roof

   A metal roof is a roofing system featuring metal pieces or tiles exhibiting corrosion resistance, impermeability to water, and long life. It is a component of the building envelope . The metal pieces may be a covering on a structural, non-waterproof roof, or they could be self-supporting sheets.

5. Cornice - Wikipedia

   en.wikipedia.org/wiki/Cornice

   The trim and rafters at this edge are called rakes, rake board, rake fascia, verge-boards, barge-boards or verge-or barge-rafters. [3] It is a sloped timber on the outside facing edge of a roof running between the ridge and the eave. [4] On a typical house, any gable will have two rakes, one on each sloped side.

6. Pole building framing - Wikipedia

   en.wikipedia.org/wiki/Pole_building_framing

   Wide buildings with common rafters need interior rows of posts. Sometimes rafters may be attached directly to the poles. The roof pitch of pole buildings is usually low and the roof form is usually gable or lean-to. Metal roofing is commonly used as the roofing and siding material on pole buildings.

7. Gable - Wikipedia

   en.wikipedia.org/wiki/Gable

   The gable end roof is a poor design for hurricane or tornado-prone regions. Winds blowing against the gable end can exert tremendous pressure, both on the gable and on the roof edges where they overhang it, causing the roof to peel off and the gable to cave in. [4] [5]