Search results
Results from the WOW.Com Content Network
A bus coupler is a device which is used to couple one bus to the other without any interruption in power supply and without creating hazardous arcs. A bus coupler is a breaker used to couple two busbars to perform maintenance on other circuit breakers associated with that busbar. It is achieved with the help of a circuit breaker and isolators.
Both ends of the bus, whether it includes one coupler or a series of couplers connected together, must be terminated (in accordance with MIL-STD-1553B) with "a resistance, equal to the selected cable nominal characteristic impedance (Zo) ± 2.0 percent."
In electric power distribution, a busbar (also bus bar) is a metallic strip or bar, typically housed inside switchgear, panel boards, and busway enclosures for local high current power distribution. They are also used to connect high voltage equipment at electrical switchyards, and low-voltage equipment in battery banks .
At the two ends of the bus, resistors connect between the positive (high) and negative (low) signal wires either in internally terminated bus couplers or external connectorized terminators. The MIL-STD-1553B bus must be terminated at both ends to minimize the effects of signal reflections that can cause waveform distortion and disruption or ...
A coupling or coupler is a mechanism, typically located at each end of a rail vehicle, that connects them together to form a train. The equipment that connects the couplers to the vehicles is the draft gear or draw gear, which must absorb the stresses of the coupling and the acceleration of the train.
A 10 dB 1.7–2.2 GHz directional coupler. From left to right: input, coupled, isolated (terminated with a load), and transmitted port. A 3 dB 2.0–4.2 GHz power divider/combiner. Power dividers (also power splitters and, when used in reverse, power combiners) and directional couplers are passive devices used
Svetlana Dali, the woman accused of stowing away on a flight from New York to Paris, was arrested again, according to the FBI.
The last link is the floating link, which is also called a coupler or connecting rod because it connects an input to the output. Assuming the frame is horizontal there are four possibilities for the input and output links: [2] A crank: can rotate a full 360 degrees; A rocker: can rotate through a limited range of angles which does not include 0 ...