enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hendrickson Holdings - Wikipedia

   en.wikipedia.org/wiki/Hendrickson_Holdings

   Hendrickson logo. Hendrickson Holdings, L.L.C. is a privately held American holding company located in Woodridge, Illinois which, through its subsidiaries, designs and manufactures medium- and heavy-duty mechanical, elastomeric and air suspensions; integrated and non-integrated axle and brakes systems; tire pressure control systems; auxiliary lift axle systems; parabolic and multi-leaf springs ...

3. Air suspension - Wikipedia

   en.wikipedia.org/wiki/Air_suspension

   Air line failure is a failure of the tubing which connects the air bags or struts to the rest of the air system, and is typically DOT-approved nylon air brake line. This usually occurs when the air lines, which must be routed to the air bags through the chassis of the vehicle, rub against a sharp edge of a chassis member or a moving suspension ...

4. Mack Granite - Wikipedia

   en.wikipedia.org/wiki/Mack_Granite

   The base rear suspension is a Mack tandem (two powered axles). Granites are also available with single and tridem (three driven) axles, different axle/suspension combination types. Lift axles can be installed by either Mack or bodybuilders. Up to three axles can be driven. Wheelbases are from 149 to 304 inches (380 to 770 cm)

5. M19 tank transporter - Wikipedia

   en.wikipedia.org/wiki/M19_Tank_Transporter

   The front axle suspension system was trailing beam assemblies on coil springs, with a dual tire wheel on each side of the beam. With an assembly on each side there were four wheels on the axle line. [17] The rear tandem beam assembly was a center pivot type, with axles on both ends of the beam.

6. M123 and M125 10-ton 6x6 trucks - Wikipedia

   en.wikipedia.org/wiki/M123_and_M125_10-ton_6x6...

   The front beam axle was mounted on leaf springs, the rear tandem beam axles were mounted on a leaf sprung "walking beam" type suspension. All models shared a 181 inches (4.60 m) wheelbase (measured from the 1st to the 3rd axles). Full air drum brakes were used. The M123 was able to control the trailer brakes independently of the tractor.

7. Mack Anthem - Wikipedia

   en.wikipedia.org/wiki/Mack_Anthem

   A ladder frame with beam axles is used. There is a single front axle on semi-elliptical leaf springs. The base rear suspension is a Mack tandem with two powered axles, a single rear drive axle with an undriven pusher axle is available. Wheelbases are from 174 to 203 inches (440 to 520 cm) A set-back front axle is used.