enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hand saw - Wikipedia

   en.wikipedia.org/wiki/Hand_saw

   Ancient bow saws have been found in Japan. The cut patterns on ancient boards may be observed sometimes to bear the unique cutting marks left by saw blades, particularly if the wood was not 'smoothed up' by some method. As for preservation of hand saws, twenty-four saws from eighteenth-century England are known to survive. [1]

3. Panel saw - Wikipedia

   en.wikipedia.org/wiki/Panel_saw

   Panel saws can be vertical or horizontal. Typically, vertical saws take up less floor space. Horizontal machines are typically large table saws with a sliding feed table that pushes the material through the blade. Table saws without the sliding feed table can also cut sheet goods. Vertical saws have two cost types, low cost and higher cost.

4. Replacing your plastic cutting board and utensils with wood ...

   www.aol.com/lifestyle/replacing-plastic-cutting...

   Food-safe wooden kitchen tools are generally low-risk so long as you care for them properly. But there are considerations when it comes to preparing or cutting meat.

5. File (tool) - Wikipedia

   en.wikipedia.org/wiki/File_(tool)

   Planemaker's float Floats are straight, single-cut files which taper used for cutting, flattening and smoothing wood, particularly in making wooden hand planes. Round parallel files are similar to round files, except that they do not taper. Shaped like a toothed cylinder. Saw sharpening files are usually single cut to deliver a smooth finish ...

6. Mitre box - Wikipedia

   en.wikipedia.org/wiki/Mitre_box

   The workpiece is placed in the box and the point at which the board is to be cut is lined up with the appropriate slot in the sides of the mitre box. The workpiece is then held or clamped in place. Backsaws are the most common hand saw used with mitre boxes, but other types of hand saw are also used. The saw is placed between the slots before ...

7. Riving knife - Wikipedia

   en.wikipedia.org/wiki/Riving_knife

   Saw blade "grabbing" occurs more frequently during ripping than cross-cutting (cuts made to wood or stone across its main grain or axis). It can occur with both hand saws and bandsaws but is more dangerous with a circular saw as areas of the circular blade close to the cutting area are moving in different directions. If a bandsaw grabs, the ...