Search results
Results from the WOW.Com Content Network
A hybrid coil accomplishes the conversion for both. At the central office, it is part of a four-wire terminating set, more often as part of a line card. A modern line card has no two-to-four wire conversion whatsoever; it is strictly an analog/digital interface to a system that has a completely digital and integrated signal path internally.
Two identical amplifiers are most often encountered in a common case, with a common power supply, and would normally be regarded as a stereo amplifier. Any conventional stereo amplifier can be operated in bridge or parallel mode provided that the common loudspeaker terminals (normally black) are connected and common to the ground rail within ...
Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two conductors) runs from the amplifier output to the terminals at the loudspeaker housing.
Telephone hybrid transformer at the interface of the four-wire long-distance trunk and the two-wire local loop. Z B is the balance termination. NBOC is the network build-out capacitor, which is set to the average shunt capacitance through the telephone central office switch. Red arrows show relative current flow.
Audio stereo power amplifier made by McIntosh The internal view of a Mission Cyrus One hi-fi integrated audio amplifier (1984) [1]. An audio power amplifier (or power amp) amplifies low-power electronic audio signals, such as the signal from a radio receiver or an electric guitar pickup, to a level that is high enough for driving loudspeakers or headphones.
Bi-amping is the use of two channels of amplification to power each loudspeaker within an audio system. Tri-amping is the practice of connecting three channels of amplification to a loudspeaker unit: one to power the bass driver , one to power the mid-range and the third to power the treble driver .
To allow the construction of hybrid systems, where the 4–20 mA is generated by the controller, but allows the use of pneumatic valves, a range of current to pressure (I to P) converters are available from manufacturers. These are usually local to the control valve and convert 4–20 mA to 3–15 psi (or 0.2–1.0 bar).
An (orange-epoxy) encapsulated hybrid circuit on a printed circuit board (PCB).. A hybrid integrated circuit (HIC), hybrid microcircuit, hybrid circuit or simply hybrid is a miniaturized electronic circuit constructed of individual devices, such as semiconductor devices (e.g. transistors, diodes or monolithic ICs) and passive components (e.g. resistors, inductors, transformers, and capacitors ...