Search results
Results from the WOW.Com Content Network
Then, the command ipconfig /renew is executed to request a new IP address. [3] [4] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is taken ...
The person at computer B issues the modem escape command. (Alternately, and more commonly, the computer B could drop the DTR, or Data Terminal Ready signal, to achieve a hangup, without needing to use +++ or ATH.) OK: The modem acknowledges it. ATH: The person at computer B issues a hang up command. NO CARRIER: OK
The connection remains, but the modem can accept commands, such as "ATH" for hangup. The computer can issue the "ATO" command to return to data mode. The computer instructed the modem to terminate the call by setting the Data Terminal Ready (DTR) pin to an "off" state.
2. Enter your username or email address and password. 3. Click Sign On. 4. Add your location name and connection type. 5. Click Next twice. 6. Select your dialing options. 7. Click Next. 8. Enter your Area Code and click Next. 9. Select 2-3 AOL access phone numbers. 10. Click Next twice to confirm your choices. 11. Click Save and then Save Changes.
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
kppp – A kde GUI frontend for pppd.; gnome-ppp – A (discontinued) gnome GUI frontend for WvDial, which in turns depends on pppd.; pppconfig – It uses the standard ppp configuration files and sets ppp up so that the standard pon and poff commands (to connect and disconnect) and plog (to list the log) can be used to control ppp.
This results in a response from the modem of CONNECT or VCON. (Modems using the "plus" command set usually respond CONNECT, while those using the "hash" set respond VCON, which stands for voice connect.) From then on, the modem interprets any data sent from the computer as wave audio data, using the codec selected by the AT+VSM or AT#VSM command.
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...