enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   DIN 72552 is a DIN standard for labeling the electric terminals in automotive wiring. The most frequently used labels are listed in the table below. ... main terminal ...

3. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   The plug for SAE J560 is physically identical to the connector ISO 1185. The difference is that J560 indicates that the voltage must be 12 V and that wire areas shall be larger due to the higher currents needed when using 12 V compared to 24 V. Some of the pins in the connector have also a slightly different function.

4. SAE J1772 - Wikipedia

   en.wikipedia.org/wiki/SAE_J1772

   SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler".

5. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available. In some cases the blade is an integral manufactured part of a component (such as a switch or a speaker unit), and the reciprocal connector terminal is pushed onto the device's connector ...

7. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   Upon researching, we found that there is no specification addressing the SAE 2 Pin overmold connector. SAE (Society of Automotive Engineers) Specification J928 addresses “Electrical Terminals – Pin and Receptacle Type” and SAE J1239 addresses 4, 5, and 8 pin trailer connectors, but there doesn’t seem to be an SAE specification for the 2 ...