Search results
Results from the WOW.Com Content Network
Drawings of various types of semiwadcutter bullets 4-cavity Keith semiwadcutter bullet mold, the Lyman 358429. The semiwadcutter design consists of a roughly conical shape with the tip truncated flat (called a meplat), sitting on a cylinder (A at right). The base of the cone is slightly smaller in diameter than the cylinder, leaving a sharp ...
It was originally named the MMJ 5.7mm [1] by its designer and is also known in the U.S. as the 5.7mm Johnson, the Johnson MMJ 5.7mm Spitfire, and the .22 Johnson, (or 5.7×33mm internationally). In 1963, Melvin M. Johnson developed a conversion of the M1 Carbine (by either relining or re-barreling the M1 Carbine ) to a .224 caliber bore, using ...
The Enfield Pattern 1853 rifle-musket (also known as the Pattern 1853 Enfield, P53 Enfield, and Enfield rifle-musket) was a .577 calibre Minié-type muzzle-loading rifled musket, used by the British Empire from 1853 to 1867; after which many were replaced in service by the cartridge-loaded Snider–Enfield rifle.
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
Since a straight-walled rimless cartridge is designed to headspace off of the case mouth, this prevents the ammunition loader or manufacturer from using a heavy crimp, which is a ring pinched or "crimped" into the cartridge case, designed to lock the bullet securely in place until fired.
A long tube of thin paper, which holds the bullet at one end, and the stiffened powder container at the other; The bullet end of the cartridge was crimped shut, and the powder end was filled and folded closed. The bullet end of the completed cartridge was then dipped in a mixture of melted beeswax and tallow to lubricate the bullet. [1]
An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.
Bullets had the manufacturer code over the Quarter number and two-digit year of production engraved on the base (e.g. Pk/2-26 is Zaklady Amunicyjne, Pocisk, 2nd Quarter of 1926). 8mm Lebel "Balle D" bullets were differenced from 7.9mm Mauser bullets by a capital letter "D" inset between the contractor code and the date (e.g. Pk/D/2-26).