Search results
Results from the WOW.Com Content Network
Contention in a wireless or noisy spectrum, where the physical medium is entirely out of the control of those who specify the protocol, requires measures that also use up throughput. Wireless devices, BPL , and modems may produce a higher line rate or gross bit rate , due to error-correcting codes and other physical layer overhead.
A wireless network interface controller may be implemented as an expansion card and connected using PCI bus or PCIe bus, or connected via USB, PC Card, ExpressCard, Mini PCIe or M.2. The low cost and ubiquity of the Wi-Fi standard means that many newer mobile computers have a wireless network interface built into the motherboard.
Allows more flexible motherboard design, component positioning and shape. Can be smaller than regular microATX. Mini-ITX: VIA: 2001 170 × 170 mm max (6.7 × 6.7 in) A small, highly integrated form factor, designed for small devices such as thin clients and set-top boxes. Nano-ITX: VIA 2003 120 × 120 mm (4.7 × 4.7 in)
Wireless LAN (WLAN) channels are frequently accessed using IEEE 802.11 protocols. The 802.11 standard provides several radio frequency bands for use in Wi-Fi communications, each divided into a multitude of channels numbered at 5 MHz spacing (except in the 45/60 GHz band, where they are 0.54/1.08/2.16 GHz apart) between the centre frequency of the channel.
The document defines a standard connector (AMP* 3-179397-0), mechanical elements including several form factors, and electrical interface. The 30-pin connector carries power, several audio channels and AC-Link serial data. Up to two AC'97 codecs are supported on such a card. Several form factors are specified: 45 × 27 mm; 45 × 37 mm
[4] As with the audio/modem riser (AMR), CNR had the cost savings potential for manufacturers by removing analog I/O components from the motherboard. This allowed the manufacturer to only certify with the Federal Communications Commission (FCC) for the CNR card, and not the entire motherboard. This resulted in a quicker production-to-market ...
Comparison of SWG (red), AWG (blue) and IEC 60228 (black) wire gauge sizes from 0.03 to 200 mm² to scale on a 1 mm grid – in the SVG file, hover over a size to highlight it. In engineering applications, it is often most convenient to describe a wire in terms of its cross-section area, rather than its diameter, because the cross section is directly proportional to its strength and weight ...
Category 4 cable (Cat 4) is a cable that consists of eight copper wires arranged in four unshielded twisted pairs (UTP) supporting signals up to 20 MHz. [1] It is used in telephone networks which can transmit voice and data up to 16 Mbit /s.