Search results
Results from the WOW.Com Content Network
A hell-fire trigger is a device that allows a semi-automatic firearm to fire at an increased rate. The hell-fire clamps to the trigger guard behind the trigger and presses a "finger" against the back of the trigger to increase the force that returns the trigger to its forward position, effectively decreasing the time required for the trigger to reset, allowing for a faster follow-up shot.
Firearms use triggers to initiate the firing of a cartridge seated within the gun barrel chamber.This is accomplished by actuating a striking device through a combination of mainspring (which stores elastic energy), a trap mechanism that can hold the spring under tension, an intermediate mechanism to transmit the kinetic energy from the spring releasing, and a firing pin to eventually strike ...
Sear shown in a revolver action. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
A Glock switch functions by applying force to a semi-automatic pistol's trigger bar to prevent it from limiting fire to one round of ammunition per trigger pull. [5] [6] Normally, in a semiautomatic pistol, after firing, the trigger bar catches the firing pin until the trigger is released, but when depressed by the switch it does not catch.
A disassembled Mauser action showing a partially disassembled receiver and bolt. In firearms terminology and law, the firearm frame or receiver is the part of a firearm which integrates other components by providing housing for internal action components such as the hammer, bolt or breechblock, firing pin and extractor, and has threaded interfaces for externally attaching ("receiving ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A trigger disconnector captures the hammer in the cocked position after a shot has been fired, even if the trigger is held to the rear as the gun cycles. This ensures the gun can only fire in the semi-automatic mode, as the trigger needs to be released to 'reset' and have the disconnector release the hammer back to the trigger sear.
This was initially to provide a longer-grip, higher capacity version of the Glock 19 (Glock 19X and Glock 45), but Glock developed the Glock 47 for US Customs and Border Patrol which used the G45 frame with a G17 length slide that included a front section to fill in the gap between the dust cover and the front of the slide, a design that fits ...