Search results
Results from the WOW.Com Content Network
The Barcol hardness test is generally used on soft materials such as rigid plastics. It measures hardness based on indentation of a sharp point with a flat tip. The test is performed using a similar method and indentation device as that used to measure Shore D hardness, however the Shore D indentor has a round tip. [4]
This derived distribution can be used to determine how often the difference in dimensions will be less than zero (i.e., the shaft cannot fit in the hole), how often the difference will be less than the required sliding gap (the shaft fits, but too tightly), and how often the difference will be greater than the maximum acceptable gap (the shaft ...
The .219 Zipper is the parent case of the .219 Donaldson Wasp, and P.O. Ackley created the .219 Zipper Improved in 1937. Leslie Lindahl's Chucker and Super-chucker and "wildcat" case modifications by Hervey Lovell, Lysle Kilbourne, and W. F. Vickery offered similarly superior ballistics in stronger single-shot and bolt actions.
A Ziploc-branded storage bag Close-up from a cross section of the sealing mechanism. A zipper storage bag, slider storage bag, zipper bag, zip lock bag, or zippie is an inexpensive flexible rectangular storage bag, usually transparent, made of polyethylene [1] [2] or similar plastic, that can be sealed and opened many times, either by a slider, which works in a similar way to a zip fastener ...
The two methods are also compared in Figure 3, created by Matlab simulation. The contours are lines of constant ratio of the times it takes to perform both methods. When the overlap-add method is faster, the ratio exceeds 1, and ratios as high as 3 are seen. Fig 3: Gain of the overlap-add method compared to a single, large circular convolution.
Indentation force-deflection is a process used in the flexible foam manufacturing industry to assess the "softness" of a sample of foam such as memory foam.To conduct an IFD test, a circular flat indenter with a surface area of 323 square centimeters (50 sq. inches - 8" in diameter) is pressed against a foam sample usually 100 mm thick and with an area of 500 mm by 500 mm (ASTM standard D3574).
The test was developed by Frederick Knoop [2] and colleagues at the National Bureau of Standards (now NIST) of the United States in 1939, and is defined by the ASTM E384 standard. The advantages of the test are that only a very small sample of material is required, and that it is valid for a wide range of test forces.
The overlap coefficient, [note 1] or Szymkiewicz–Simpson coefficient, [citation needed] [3] [4] [5] is a similarity measure that measures the overlap between two finite sets.It is related to the Jaccard index and is defined as the size of the intersection divided by the size of the smaller of two sets: