Search results
Results from the WOW.Com Content Network
An emitting pipe is a type of drip irrigation tubing with emitters pre-installed at the factory with specific distance and flow per hour as per crop distance. An emitter restricts water flow passage through it, thus creating head loss required (to the extent of atmospheric pressure) to emit water in the form of droplets.
The original field emitter array was the Spindt array, in which the individual field emitters are small sharp molybdenum cones. Each is deposited inside a cylindrical void in an oxide film, with a counterelectrode deposited on the top of the film. The counterelectrode (called the "gate") contains a separate circular aperture for each conical ...
The input signal is applied across the ground and the base circuit of the transistor. The output signal appears across ground and the collector of the transistor. Since the emitter is connected to the ground, it is common to signals, input and output. The common-emitter circuit is the most widely used of junction transistor amplifiers.
The transistor continuously monitors V diff and adjusts its emitter voltage to equal V in minus the mostly constant V BE (approximately one diode forward voltage drop) by passing the collector current through the emitter resistor R E. As a result, the output voltage follows the input voltage variations from V BE up to V +; hence the name ...
An electron gun (also called electron emitter) is an electrical component in some vacuum tubes that produces a narrow, collimated electron beam that has a precise kinetic energy. The largest use is in cathode-ray tubes (CRTs), used in older television sets , computer displays and oscilloscopes , before the advent of flat-panel displays .
Emitter may refer to: Devices which emit charged particles. Cathode, or negative electrode, in a vacuum tube or diode; Anode, or positive electrode, in certain ...
A Class B push–pull output driver using a pair of complementary PNP and NPN bipolar junction transistors configured as emitter followers. A push–pull amplifier is a type of electronic circuit that uses a pair of active devices that alternately supply current to, or absorb current from, a connected load.
Schottky-emitter electron source of an Electron microscope. A field emission gun (FEG) is a type of electron gun in which a sharply pointed Müller-type [clarification needed] emitter [1]: 87–128 is held at several kilovolts negative potential relative to a nearby electrode, so that there is sufficient potential gradient at the emitter surface to cause field electron emission.