Search results
Results from the WOW.Com Content Network
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
Sound intensity, also known as acoustic intensity, is defined as the power carried by sound waves per unit area in a direction perpendicular to that area, also called the sound power density and the sound energy flux density. [2] The SI unit of intensity, which includes sound intensity, is the watt per square meter (W/m 2).
While 1 atm (194 dB peak or 191 dB SPL) [11] [12] is the largest pressure variation an undistorted sound wave can have in Earth's atmosphere (i. e., if the thermodynamic properties of the air are disregarded; in reality, the sound waves become progressively non-linear starting over 150 dB), larger sound waves can be present in other atmospheres ...
Audiogram. An audiogram is a graph that shows the audible threshold for standardized frequencies as measured by an audiometer.The Y axis represents intensity measured in decibels (dB) and the X axis represents frequency measured in hertz (Hz). [1]
Transmission loss in underwater acoustics describes the decrease of sound intensity that is reduced by a bubble curtain or other damping structure at a given frequency. The same term is sometimes used to mean propagation loss , which is a measure of the reduction in sound intensity between the sound source and a receiver, defined as the ...
Equal-loudness contours. The phon is a logarithmic unit of loudness level for tones and complex sounds. Loudness is measured in sones, a linear unit.Human sensitivity to sound is variable across different frequencies; therefore, although two different tones may present an identical sound pressure to a human ear, they may be psychoacoustically perceived as differing in loudness.
While describing sound in terms of sound pressure, a logarithmic conversion is usually applied and the sound pressure level is stated instead, in decibels (dB), with 0 dB SPL equal to 20 micropascals. A microphone is distinguishable by the voltage value produced when a known, constant root mean square sound pressure is applied. This is known as ...
The frequency and amplitude axes can be either linear or logarithmic, depending on what the graph is being used for. Audio would usually be represented with a logarithmic amplitude axis (probably in decibels, or dB), and frequency would be linear to emphasize harmonic relationships, or logarithmic to emphasize musical, tonal relationships.