Search results
Results from the WOW.Com Content Network
A Millisecond Furnace is a device used for cracking naphtha into ethylene, [1] by extremely short (50 to 100 millisecond) exposure to temperatures of about 900 degrees Celsius, followed by a rapid quenching below 750 degrees Celsius. It was developed by M. W. Kellogg and Idemitsu in the 1970s. [2]
An oil burner is a part attached to an oil furnace, water heater, or boiler. [1] It provides the ignition of heating oil/biodiesel fuel used to heat either air or water via a heat exchanger . The fuel is atomized into a fine spray usually by forcing it under pressure through a nozzle which gives the resulting flame a specific flow rate, angle ...
High energy ignition, also known as H.E.I., is an electronic ignition system designed by the Delco-Remy Division of General Motors. It was used on all GM vehicles, at least in the North American market, from 1975 through the mid-1980s.
As batteries became more common in cars (due to the increased usage of electric starter motors), magneto systems were replaced by systems using an induction coil.The 1886 Benz Patent-Motorwagen and the 1908 Ford Model T used a trembler coil ignition system, whereby the trembler interrupted the current through the coil and caused a rapid series of sparks during each firing.
An industrial chamber furnace, used to heat steel billets for open-die forging. An industrial furnace, also known as a direct heater or a direct fired heater, is a device used to provide heat for an industrial process, typically higher than 400 degrees Celsius. [1]
A schematic diagram of a Visbreaker unit. The term coil (or furnace) visbreaking is applied to units where the cracking process occurs in the furnace tubes (or "coils")."). Material exiting the furnace is quenched to halt the cracking reactions: frequently this is achieved by heat exchange with the virgin material being fed to the furnace, which in turn is a good energy efficiency step, but ...
Now it is more common to light a burner electrically, but gas pilot lights are still used when a high energy ignition source is necessary, as in when lighting a large burner. A United States patent was filed May 13, 1922, for a "safety gas-control system" by two employees of the Newark, New Jersey–based Public Service Gas Company, Conrad ...
Loss on ignition (LOI) is a test used in inorganic analytical chemistry and soil science, particularly in the analysis of minerals and the chemical makeup of soil. It consists of strongly heating ( "igniting" ) a sample of the material at a specified temperature, allowing volatile substances to escape, until its mass ceases to change.