Search results
Results from the WOW.Com Content Network
Oil conversion factor from m³ to bbl (or stb) is 6.28981100 Gas conversion factor from standard m³ to scf is 35.314666721 Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
The fuel consumption is an equivalent measure for cars sold outside the United States, typically measured in litres per 100 km traveled; in general, the fuel consumption and miles per gallon would be reciprocals with appropriate conversion factors, but because different countries use different driving cycles to measure fuel consumption, fuel ...
The British imperial system uses a stone of 14 lb, a long hundredweight of 112 lb and a long ton of 2,240 lb. The stone is not a measurement of weight used in the US. The US customary system uses the short hundredweight of 100 lb and short ton of 2,000 lb. Where these systems most notably differ is in their units of volume.
Metric regions commonly use the tonne of oil equivalent (toe), or more often million toe (Mtoe). Since this is a measurement of mass, any conversion to barrels of oil equivalent depends on the density of the oil in question, as well as the energy content. Typically 1 tonne of oil has a volume of 1.08 to 1.19 cubic metres (6.8 to 7.5 bbl).
The first group of metric units are those that are at present defined as units within the International System of Units (SI). In its most restrictive interpretation, this is what may be meant when the term metric unit is used. The unit one (1) is the unit of a quantity of dimension one. It is the neutral element of any system of units. [2]
2 Chipte = 1 Mapte (about half litre) 2 Mapte = 1 Ser (about one litre) Liquid Volume Measures. These were hour glass shaped measure used for Milk, Ghee, Oils. The bottom was round like an inverted dome, the top was like flared rim. This shape helped in pouring the liquids. 4 Chhataank = 1 Pav 4 Pav = 1 Seer 40 Seer = 1 Maund Length Measure
In physics and chemistry, it is common to measure energy on the atomic scale in the non-SI, but convenient, units electronvolts (eV). 1 eV is equivalent to the kinetic energy acquired by an electron in passing through a potential difference of 1 volt in a vacuum. It is common to use the SI magnitude prefixes (e.g. milli-, mega- etc) with ...
Last, multiply the original expression of the physical value by the fraction, called a conversion factor, to obtain the same physical value expressed in terms of a different unit. Note: since valid conversion factors are dimensionless and have a numerical value of one , multiplying any physical quantity by such a conversion factor (which is 1 ...