Search results
Results from the WOW.Com Content Network
A relay Electromechanical relay principle Electromechanical relay schematic showing a control coil, four pairs of normally open and one pair of normally closed contacts An automotive-style miniature relay with the dust cover taken off. A relay is an electrically operated switch. It consists of a set of input terminals for a single or multiple ...
The operating time of relay decreases with the increases in the current. The operation of the relay depends on the magnitude of the current. [33] An inverse definite minimum time (IDMT) relay is a protective relay which is developed to overcome the shortcomings of the definite time overcurrent (DTOC) relays. [1]: pp 30-31 [34]: 134
In electrical systems, a static relay is a type of relay, an electrically operated switch, that has no moving parts. [1] Static relays are contrasted with electromechanical relays, which use moving parts to create a switching action. Both types of relay control electrical circuits through a switch that is open or closed depending upon an ...
Commonly-used circuit symbol Operation of the reed switch The reed switch [ i ] is an electromechanical switch operated by an applied magnetic field . It was invented in 1922 by professor Valentin Kovalenkov at the Petrograd Electrotechnical University , [ 1 ] and later evolved at Bell Telephone Laboratories in 1936 by Walter B. Ellwood into ...
A solid state relay (SSR) is an electronic switching device that switches on or off when an external voltage (AC or DC) is applied across its control terminals. They serve the same function as an electromechanical relay , but solid-state electronics contain no moving parts and have a longer operational lifetime.
Normally closed mercury relay, with coil around top of tube and adjustable angle. A mercury relay (mercury displacement relay, mercury contactor) is a relay that uses mercury as the switching element. They are used as high-current switches or contactors, where contact erosion from constant cycling would be a problem for conventional relay contacts.
A normal relay uses a wire coil and the mechanical movement of the metal contacts to switch the load on and off. The metal contacts may weld shut after repeated operation cycles. If this happens, the machine would continue running if the operator pressed the emergency stop pushbutton. This would be hazardous for the operator.
In many cases, it is possible to design a relay logic diagram directly from the narrative description of a control event sequence. In general, the following suggestions apply to designing a relay logic diagram: 1. Define the process to be controlled. 2. Draw a sketch of the operation process. Make sure all the components of the system are ...