Search results
Results from the WOW.Com Content Network
The fuel consumption is an equivalent measure for cars sold outside the United States, typically measured in litres per 100 km traveled; in general, the fuel consumption and miles per gallon would be reciprocals with appropriate conversion factors, but because different countries use different driving cycles to measure fuel consumption, fuel ...
The scientific study of factors such as these is called tribology. [9] Pressure-relief systems (also called piston lubrication systems or positive displacement injector (PDI) systems) use a piston to apply an accurate lubricant volume to the lubrication point. A pressure relief system is used when the volume of lubricant applied must be precise ...
The oil and the oil filter need to be periodically replaced; the process is called an oil change. While there is an entire industry surrounding regular oil changes and maintenance, an oil change is a relatively simple car maintenance operation that many car owners can do themselves.
Systems that measure large fuel tanks (including underground storage tanks) may use the same electro-mechanical principle or may make use of a pressure sensor, [9] sometimes connected to a mercury manometer. Many large transport aircraft use a different fuel gauge design principle.
A modern gasoline pump is divided into two main parts – an electronic "head" containing an embedded computer to control the action of the pump, drive the pump's displays, and communicate to an indoor sales system; and a mechanical section which (in a self-contained unit) has an electric motor, pumping unit, meters, pulsers and valves to ...
For the conversion amongst units of energy in the following table, 1 litre of petrol amounts to 34.2 MJ, 1 kWh amounts to 3.6 MJ and 1 kilocalorie amounts to 4184 J. For the car occupation ratio, the value of 1.2 passengers per automobile [13] was considered. Nonetheless, in Europe this value slightly increases to 1.4. [14]
A pumped oil system can use higher oil pressures and so makes the use of hydrostatic bearings easier. These gave a greater load capacity and soon became essential for small, lightweight engines such as in cars. It was this bearing design that saw the end of splash lubrication and total loss oiling.
US dry barrel: 7,056 cubic inches (115.6 litres; 3.3 US bushels) . Defined as length of stave 28 + 1 ⁄ 2 in (72 cm), diameter of head 17 + 1 ⁄ 8 in (43 cm), distance between heads 26 in (66 cm), circumference of bulge 64 in (160 cm) outside measurement; representing as nearly as possible 7,056 cubic inches; and the thickness of staves not greater than 4 ⁄ 10 in (10 mm) [2] (diameter ≈ ...