Search results
Results from the WOW.Com Content Network
However, the lower refresh rate of 50 Hz introduces more flicker, so sets that use digital technology to double the refresh rate to 100 Hz are now very popular. (see Broadcast television systems ) Another difference between 50 Hz and 60 Hz standards is the way motion pictures (film sources as opposed to video camera sources) are transferred or ...
A refresh rate of 60 Hz on most screens will produce a visible "flickering" effect. Most people find that refresh rates of 70–90 Hz and above enable flicker-free viewing on CRTs. Use of refresh rates above 120 Hz is uncommon, as they provide little noticeable flicker reduction and limit available resolution.
On displays with a fixed refresh rate, a frame can only be shown on the screen at specific intervals, evenly spaced apart. If a new frame is not ready when that interval arrives, then the old frame is held on screen until the next interval (stutter) or a mixture of the old frame and the completed part of the new frame is shown ().
The second revision ("XGA-2") was a more thorough upgrade, offering higher refresh rates (75 Hz and up, non-interlaced, up to at least 1024×768), improved performance, and a fully programmable display engine capable of almost any resolution within its physical limits.
Cyclic rate of a typical automobile engine at idle (equivalent to 600 rpm) 12 Hz: Acoustic – the lowest possible frequency that a human can hear [3] 18 Hz: Average house cat's purr 24 Hz: Common frame rate of movies 27.5 Hz: Acoustic – the lowest musical note (A 0) playable on a normally-tuned standard piano 50 Hz
This is a list of films with high frame rates. Only films with a native (without motion interpolation ) shooting and projection frame rate of 48 or higher, for all or some of its scenes , are included, as are films that received an official post-conversion using technologies such as TrueCut Motion.
Typically less than 0.01 ms, as low as 2 μs, [10] [14] but limited by phosphor decay time (around 5 ms) Estimates varying from under 0.01 ms to as low as 1 μs. [15] [16] Frame rate (refresh rate) 60–85 fps typically, some CRTs can go even higher (200 fps at reduced resolution [17]); internally, display refreshed at input frame rate speed
Television typically originates at 50 or 60 frames or interlaced fields per second. The flicker fusion threshold does not prevent indirect detection of a high frame rate, such as the phantom array effect or wagon-wheel effect, as human-visible side effects of a finite frame rate were still seen on an experimental 480 Hz display. [6]