Search results
Results from the WOW.Com Content Network
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
Furniture, fixtures, and equipment (or FF&E) (sometimes Furniture, furnishings, and equipment [1] [2]) is an accounting term used in valuing, selling, or liquidating a company or a building. FF&E are movable furniture , fixtures , or other equipment that have no permanent connection to the structure of a building or utilities. [ 3 ]
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.
A low-flow fixture is a water saving plumbing fixture designed to achieve water savings by having a lower flow rate of water or a smaller quantity per flush. Some of these low-flow fixtures are faucets , showerheads, and toilets .
if a fixture unit were one cubic foot per minute then it would also be 7.48 gallons per minute. —Preceding unsigned comment added by 75.172.153.197 ( talk ) 23:21, 26 June 2008 (UTC) [ reply ] Uh, this is in the category of flow rate units, but the article claims it is not a flow rate unit.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
The main units of length (inch, foot, yard and international mile) were the same in the US, though the US rarely uses some of the intermediate units today, such as the (surveyor's) chain (22 yards) and the furlong (220 yards). At one time, the definition of the nautical mile was based on the surface area of the Clarke ellipsoid.
A foot-candle (sometimes foot candle; abbreviated fc, lm/ft 2, or sometimes ft-c) is a non-SI unit of illuminance or light intensity. The foot-candle is defined as one lumen per square foot. This unit is commonly used in lighting layouts in parts of the world where United States customary units are used, mainly the United States. [ 1 ]