Search results
Results from the WOW.Com Content Network
In the functional safety standards based on the IEC 61508 standard, four SILs are defined, with SIL4 being the most dependable and SIL1 the least. The applicable SIL is determined based on a number of quantitative factors in combination with qualitative factors, such as risk assessments and safety lifecycle management. Other standards, however ...
In engineering, a factor of safety (FoS) or safety factor (SF) expresses how much stronger a system is than it needs to be for an intended load.Safety factors are often calculated using detailed analysis because comprehensive testing is impractical on many projects, such as bridges and buildings, but the structure's ability to carry a load must be determined to a reasonable accuracy.
Mean Time to Dangerous Failure. In a safety system MTTF D is the portion of failure modes that can lead to failures that may result in hazards to personnel, environment or equipment. MTTF D is critical to the determination of the performance level of a safety system. ISO 13849 defines three levels of MTTF D:
Performance: speed at which the Work Center runs as a percentage of its designed speed. Quality: Good Units produced as a percentage of the Total Units Started. It is commonly referred to as the first pass yield (FPY). To calculate the Total Effective Equipment Performance(TEEP), the OEE is multiplied by a fourth component:
A defect can be defined as a nonconformance of a quality characteristic (e.g. strength, width, response time) to its specification. DPMO is stated in opportunities per million units for convenience: processes that are considered highly capable (e.g., processes of Six Sigma quality) are those that experience fewer than 3.4 defects per million ...
Safety engineering is an engineering discipline which assures that engineered systems provide acceptable levels of safety. It is strongly related to industrial engineering/systems engineering, and the subset system safety engineering. Safety engineering assures that a life-critical system behaves as needed, even when components fail.
Consider a quality characteristic with target of 100.00 μm and upper and lower specification limits of 106.00 μm and 94.00 μm respectively. If, after carefully monitoring the process for a while, it appears that the process is in control and producing output predictably (as depicted in the run chart below), we can meaningfully estimate its ...
An occupational safety management system (OSMS) is a management system designed to manage occupational safety and health risks in the workplace.If the system contains elements of management of longer-term health impacts and occupational disease, it may be referred to as a occupational safety and health management system (OSHMS) or occupational health and safety management system (OHSMS).