Search results
Results from the WOW.Com Content Network
IEEE 829-2008, also known as the 829 Standard for Software and System Test Documentation, was an IEEE standard that specified the form of a set of documents for use in eight defined stages of software testing and system testing, each stage potentially producing its own separate type of document. The standard specified the format of these ...
A test method is a method for a test in science or engineering, such as a physical test, chemical test, or statistical test. It is a definitive procedure that produces a test result. [ 1 ] In order to ensure accurate and relevant test results, a test method should be "explicit, unambiguous, and experimentally feasible.", [ 2 ] as well as ...
Documentation is about the testing of all the documents created prior, and after the testing of software. [4] Any delay in the testing of the document will increase the cost. [5] Some common artifacts about software development and testing can be specified as test cases, test plans, requirements, and traceability matrices.
IEEE 829 – Test Procedure Specification The Test Procedures are developed from both the Test Design and the Test Case Specification. The document describes how the tester will physically run the test, the physical set-up required, and the procedure steps that need to be followed. The standard defines ten procedure steps that may be applied ...
Test coverage in the test plan states what requirements will be verified during what stages of the product life. Test coverage is derived from design specifications and other requirements, such as safety standards or regulatory codes, where each requirement or specification of the design ideally will have one or more corresponding means of verification.
MIL-STD-498 standard describes the development and documentation in terms of 22 Data Item Descriptions (DIDs), which were standardized documents for recording the results of each the development and support processes, for example, the Software Design Description DID was the standard format for the results of the software design process.
Conformance testing — an element of conformity assessment, and also known as compliance testing, or type testing — is testing or other activities that determine whether a process, product, or service complies with the requirements of a specification, technical standard, contract, or regulation.
The Test and Evaluation Master Plan documents the overall structure and objectives of the Test & Evaluation for a program. [3] It covers activities over a program’s life-cycle and identifies evaluation criteria for the testers. [4] The test and evaluation master plan consists of individual tests. Each test contains the following. Test Scenario