enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ridgid - Wikipedia

   en.wikipedia.org/wiki/Ridgid

   The brand is best known for its distinctive red pipe wrenches, [2] [3] but the company manufactures over 300 different types of tools. [1] The company also sells power tools, largely made by TTI, and wet/dry vacs, made by parent company Emerson. [4] Ridgid produced a pinup calendar from 1935 until 2016. [5]

3. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Pass-through sockets and ratchets are built for 1 ⁄ 4-inch, 3 ⁄ 8-inch and 1 ⁄ 2-inch sets in both SAE and metric sizes. By using a fine tooth ratchet and socket system that allow a pass-through ratchet to be used as a conventional ratchet handle with interchangeable 1 ⁄ 4-inch and 3 ⁄ 8-inch drives some ratchets can be used with ...

4. Yankee screwdriver - Wikipedia

   en.wikipedia.org/wiki/Yankee_screwdriver

   North Brothers offered several different accessories to fit the various type chucks on the Yankee spiral ratchet screwdrivers. Normally, 3 different slot type tips were included with each screwdriver when it was new. [3] Other tips included: Nut drivers in various sizes, both hex and square head; Drill points for the smallest 133/135 size ...

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (metric coarse): For M7.0×1.0, major minus pitch yields 6.0, but 6.1 also works well. Example (metric fine): For M7.0×0.5, major minus pitch yields 6.5, which at 92.9% happens to be an example that pushes over the outer bound of the 90% ± 2 pp , but major minus pitch is still valid, although smaller drills (6.3 mm, 1 ⁄ 4 , 6.4 mm ...

6. Ratchet (device) - Wikipedia

   en.wikipedia.org/wiki/Ratchet_(device)

   A ratchet consists of a round gear or a linear rack with teeth, and a pivoting, spring-loaded finger called a pawl (or click, in clocks and watches [1] [2]) that engages the teeth. The teeth are uniform but are usually asymmetrical, with each tooth having a moderate slope on one edge and a much steeper slope on the other edge.

7. Brace (tool) - Wikipedia

   en.wikipedia.org/wiki/Brace_(tool)

   A brace and bit can be used to drill wider and deeper holes than can a geared hand-powered drill. The cost of the greater torque is lower rotational speed; it is easy for a geared hand drill to achieve a rotational speed of several hundred revolutions per minute, while it would require considerable effort to achieve even 100 rpm with a brace.