Search results
Results from the WOW.Com Content Network
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
These use a Chrysler custom Torqueflite 904 automatic transmission with an integral Chevrolet bellhousing. Do not confuse with later AMC 2.5 L engine that uses GM small corporate pattern . Chevrolet Turbo-Thrift engine (post-1962) Chevrolet 153 Inline 4 (Chevy II, pre-Iron-Duke - includes the Vortec 3000/181 industrial/marine crate motor)
In 2001, the engine was fitted with a variable intake control system which boosted output to 180 hp (134 kW) at 5000 rpm and 210 lb⋅ft (285 N⋅m) at 4000 rpm. The engine was especially suited for transverse applications in Chrysler's minivans, but was also used in a longitudinal front-wheel-drive setup on 1993-1997 LH platform cars.
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts.
The Polyspheric engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to its Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.
The Chrysler flathead engine is a flathead inline automotive engine manufactured by the Chrysler Corporation from 1924 through the early 1960s. It came in four-,six-, and eight-cylinder configurations and varying displacements, with both cast iron and cast aluminum cylinder heads. It was installed in Chrysler, DeSoto, Dodge, and Plymouth ...
Chrysler used a 14 mm (0.55 in) spark plug, rather than the typical 18 mm (0.71 in), in an effort to fit it as centrally as possible in the combustion chamber. [ 1 ] The intake and exhaust valves were the same size as the 426's, [ 6 ] the 2.25 in (57 mm) intake canted at 15° from the bore centerline, the 1.94 in (49 mm) exhaust at 6°. [ 6 ]