Search results
Results from the WOW.Com Content Network
As with parity RAM, additional information needs to be stored and more processing needs to be done, making ECC RAM more expensive and a little slower than non-parity and logic parity RAM. This type of ECC memory is especially useful for any application where reliability or uptime is a concern: failing bits in a memory word are detected and ...
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module. Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
Traditionally, DRAM has had the most attention in the quest to reduce or work around soft errors, due to the fact that DRAM has comprised the majority-share of susceptible device surface area in desktop, and server computer systems (ref. the prevalence of ECC RAM in server computers).
Memory diagnostic software programs (e.g., memtest86) are low-cost or free tools used to check for memory failures on a PC. They are usually in the form of a bootable software distribution on a floppy disk or CD-ROM. The diagnostic tools provide memory test patterns which are able to test all system memory in a computer.
The original IBM PC and all PCs until the early 1990s used parity checking. [12] Later ones mostly did not. An ECC-capable memory controller can generally [a] detect and correct errors of a single bit per word [b] (the unit of bus transfer), and detect (but not correct) errors of two bits
30-pin SIMM, 256 KB capacity Two 30-pin SIMM slots on an IBM PS/2 Model 50 motherboard. Standard sizes: 256 KB, 1 MB, 4 MB, 16 MB. 30-pin SIMMs have 12 address lines, which can provide a total of 24 address bits. With an 8-bit data width, this leads to an absolute maximum capacity of 16 MB for both parity and non-parity modules (the additional redundancy-bit chip usually doe
Double data rate (DDR) memory controllers are used to drive DDR SDRAM, where data is transferred on both rising and falling edges of the system's memory clock.DDR memory controllers are significantly more complicated when compared to single data rate controllers, [citation needed] but they allow for twice the data to be transferred without increasing the memory's clock rate or bus width.
A system monitor displaying system resources usage. A system monitor is a hardware or software component used to monitor system resources and performance in a computer system. [1] Among the management issues regarding use of system monitoring tools are resource usage and privacy. Monitoring can track both input and output values and events of ...