enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...

3. Fiberglass molding - Wikipedia

   en.wikipedia.org/wiki/Fiberglass_molding

   The component-making process involves building up a component on the fiberglass mold. The mold is a negative image of the component to be made, so the fiberglass will be applied inside the mold, rather than around it. As in the mold-making process, release agent is first applied to the mold. Colored gelcoat is then applied.

4. Molding (process) - Wikipedia

   en.wikipedia.org/wiki/Molding_(process)

   A mold or mould is a hollowed-out block that is filled with a liquid or pliable material such as plastic, glass, metal, or ceramic raw material. [2] The liquid hardens or sets inside the mold, adopting its shape. A mold is a counterpart to a cast. The very common bi-valve molding process uses two molds, one for each half of the object.

5. Spin casting - Wikipedia

   en.wikipedia.org/wiki/Spin_casting

   The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...

6. Ceramic mold casting - Wikipedia

   en.wikipedia.org/wiki/Ceramic_mold_casting

   It is a combination of plaster mold casting and investment casting. [2] [3] There are two types of ceramic mold casting: the Shaw process and the Unicast process. [4] These casting processes are commonly used to make tooling, especially drop forging dies, but also injection molding dies, die casting dies, glass molds, stamping dies, and ...

7. Potting (electronics) - Wikipedia

   en.wikipedia.org/wiki/Potting_(electronics)

   The mold may be part of the finished article and may provide shielding or heat dissipating functions in addition to acting as a mold. When the mold is removed the potted assembly is described as cast. [4] As an alternative, many circuit board assembly houses coat assemblies with a layer of transparent conformal coating rather than potting. [5]