Ads
related to: mitre box for large skirting metal frame wood top desk
Search results
Results from the WOW.Com Content Network
A mitre box or miter box (American English) is a wood working appliance used to guide a hand saw for making precise cuts, usually 45° mitre cuts. [ 1 ] [ 2 ] Traditional mitre boxes are simple in construction and made of wood, while adjustable mitre boxes are made of metal and can be adjusted for cutting any angle from 45° to 90°.
[citation needed] The screws go under the frame (work-piece) to be held, and the bit clamps down on the lower-edge of the frame. [citation needed] Recent designs are more complicated; a rigid body holds one fixed and one moveable jaw activated by a cam. [citation needed] An example of newer clamps is Jim Chestnut's Clam Clamp. [8]
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
A miter square or mitre square is a hand tool used in woodworking and metalworking for marking and checking angles other than 90°. Most miter squares are for marking and checking 45° angles and its supplementary angle, 135°. [1] [2] A miter is a bevelled edge – usually 45° – used, for example, for making miter joints for woodworking. [2]
Mitre square: A mitre square is used in woodworking to mark and measure 45° angles and its supplementary angle, 135°. The most common type (pictured) has a tongue set at 45° to the stock. Factory-made mitre squares usually have a metal tongue and a wooden stock, though historically woodworkers would often make their own out of wood. [16]
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame ...
The inside of the wooden stock usually has a brass strip fixed to it to reduce wear. [7] [4] On some squares the top of the stock is angled at 45°, so the square can be used as a mitre square for marking and checking 45° angles. A similar type of square is the engineer's square, used in metalworking and by some woodworkers. The blade is made ...
This design can be used for cutting mitres (angle cuts) as well as regular crosscutting, and can be well suited to precisely cutting small pieces of wood. [ 4 ] If suitably square and flush, the stop that spans the full width of the bench hook (the hook) can also be used as a fence so the bench hook can be used as a short shooting board , for ...
Ads
related to: mitre box for large skirting metal frame wood top desk