Ad
related to: mitre box for large skirting metal frame wood slat signtemu.com has been visited by 1M+ users in the past month
- Low Price Paradise
Enjoy Wholesale Prices
Find Everything You Need
- Crazy, So Cheap？
Limited time offer
Hot selling items
- All Clearance
Daily must-haves
Special for you
- Clearance Sale
Enjoy Wholesale Prices
Find Everything You Need
- Low Price Paradise
Search results
Results from the WOW.Com Content Network
A mitre box or miter box (American English) is a wood working appliance used to guide a hand saw for making precise cuts, usually 45° mitre cuts. [ 1 ] [ 2 ] Traditional mitre boxes are simple in construction and made of wood, while adjustable mitre boxes are made of metal and can be adjusted for cutting any angle from 45° to 90°.
Coping or scribing is the woodworking technique of shaping the end of a moulding or frame component to neatly fit the contours of an abutting member. Joining tubular members in metalworking is also referred to as a cope, or sometimes a "fish mouth joint" or saddle joint .
Miter squares are usually made from two fixed parts, a stock and a blade (sometimes called a tongue). The blade on a modern factory-made miter square is typically a thin piece of metal which is fixed at 45° onto or into the stock, forming a 'T' shape. The stock is usually much thicker than the blade and is made from wood, metal or plastic.
This design can be used for cutting mitres (angle cuts) as well as regular crosscutting, and can be well suited to precisely cutting small pieces of wood. [ 4 ] If suitably square and flush, the stop that spans the full width of the bench hook (the hook) can also be used as a fence so the bench hook can be used as a short shooting board , for ...
This page was last edited on 13 September 2005, at 16:24 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Mitre square: A mitre square is used in woodworking to mark and measure 45° angles and its supplementary angle, 135°. The most common type (pictured) has a tongue set at 45° to the stock. Factory-made mitre squares usually have a metal tongue and a wooden stock, though historically woodworkers would often make their own out of wood. [16]
[citation needed] The screws go under the frame (work-piece) to be held, and the bit clamps down on the lower-edge of the frame. [citation needed] Recent designs are more complicated; a rigid body holds one fixed and one moveable jaw activated by a cam. [citation needed] An example of newer clamps is Jim Chestnut's Clam Clamp. [8]
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame ...
Ad
related to: mitre box for large skirting metal frame wood slat signtemu.com has been visited by 1M+ users in the past month