Search results
Results from the WOW.Com Content Network
The engine is a V-twin four-stroke, 895 cc (54.6 cu in) or 993 cc (60.6 cu in) displacement, fan-driven air-cooled, gasoline engine design.The larger displacement is achieved by increasing the stroke from 78 to 87 mm (3.1 to 3.4 in), but using the same bore of 86 mm (3.4 in).
The Briggs & Stratton Gasoline/Electric Hybrid Car – In 1980, at the tail end of the energy crisis, Briggs & Stratton developed the first gasoline-electric hybrid automobile concept car. "The Hybrid" was designed by Brooks Stevens , had six wheels and was powered by a twin-cylinder 16 hp (11.9 kW) Briggs & Stratton engine and a large bank of ...
Hiereth et al. [30] shows a turbocharger compressor full-load, or maximum fuelling, curve runs up close to the surge line. A gas turbine compressor full-load line also runs close to the surge line. The industrial compressor overload is a capacity limit and requires high power levels to pass the high flow rates required. [31]
A choke left closed after the engine has warmed up increases the engine's fuel consumption and exhaust gas emissions, and causes the engine to run rough and lack power due to an over-rich fuel mixture. However, excessive fuel can flood an engine and prevent it from starting. To remove the excess fuel, many carburetors with automatic chokes ...
A compressor will only pump air in a stable manner up to a certain pressure ratio. Beyond this value the flow will break down and become unstable. This occurs at what is known as the surge line on a compressor map. The complete engine is designed to keep the compressor operating a small distance below the surge pressure ratio on what is known ...
Companies like Briggs and Stratton were also producing lightweight air-cooled engines in the 0.5–2 hp (0.37–1.5 kW) range and used much lighter-weight materials. These engines also run at much higher speeds (up to approximately 2,000–4,000 rpm) and therefore produce more power for a given size than slow flywheel engines.
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...
The rate does not depend on the downstream pressure at all. All other terms are constants that depend only on the composition of the material in the flow. Although the gas velocity reaches a maximum and becomes choked, the mass flow rate is not choked. The mass flow rate can still be increased if the upstream pressure is increased as this ...