Search results
Results from the WOW.Com Content Network
Simulation-based methods for time-based network analysis solve a circuit that is posed as an initial value problem (IVP). That is, the values of the components with memories (for example, the voltages on capacitors and currents through inductors) are given at an initial point of time t 0 , and the analysis is done for the time t 0 ≤ t ≤ t f ...
Differential Equations: Applied to model and analyze the behavior of circuits over time. Used in the study of filters, oscillators, and transient responses of circuits. Complex Numbers and Complex Analysis: Important for circuit analysis and impedance calculations. Used in signal processing and to solve problems involving sinusoidal signals.
Dynamic logic circuits are usually faster than static counterparts and require less surface area, but are more difficult to design. Dynamic logic has a higher average rate of voltage transitions than static logic, [ 2 ] but the capacitive loads being transitioned are smaller [ 3 ] so the overall power consumption of dynamic logic may be higher ...
These two modeling techniques use SPICE to solve a problem while the third method, digital primitives, uses mixed mode capability. Each of these methods has its merits and target applications. In fact, many simulations (particularly those which use A/D technology) call for the combination of all three approaches. No one approach alone is ...
In digital logic, a don't-care term [1] [2] (abbreviated DC, historically also known as redundancies, [2] irrelevancies, [2] optional entries, [3] [4] invalid combinations, [5] [4] [6] vacuous combinations, [7] [4] forbidden combinations, [8] [2] unused states or logical remainders [9]) for a function is an input-sequence (a series of bits) for which the function output does not matter.
Norton's theorem and its dual, Thévenin's theorem, are widely used for circuit analysis simplification and to study circuit's initial-condition and steady-state response. Norton's theorem was independently derived in 1926 by Siemens & Halske researcher Hans Ferdinand Mayer (1895–1980) and Bell Labs engineer Edward Lawry Norton (1898–1983).
Phasor notation (also known as angle notation) is a mathematical notation used in electronics engineering and electrical engineering.A vector whose polar coordinates are magnitude and angle is written . [13] can represent either the vector (, ) or the complex number + =, according to Euler's formula with =, both of which have magnitudes of 1.
To design any electrical circuit, either analog or digital, electrical engineers need to be able to predict the voltages and currents at all places within the circuit. [1] Linear circuits , that is, circuits wherein the outputs are linearly dependent on the inputs, can be analyzed by hand using complex analysis .