Search results
Results from the WOW.Com Content Network
These terminals are usually labelled as normally open, common, and normally closed (NO-C-NC). An alternate notation for Form C is SPDT. [12] These contacts are quite frequently found in electrical switches and relays as the common contact element provides a mechanically economical method of providing a higher contact count. [12]
Figure 4 illustrates a single isolated relay or actuator, in which a single-pole normally open relay is controlling the connection of the voltage source to the lamp. This relay connects one input to one output. An isolated relay can have more than one pole and can have normally closed contacts as well as normally open contacts. Figure 5.
The internals of a micro switch. Contacts, from left to right, are common, normally open, and normally closed. In one type of microswitch, [4] internally there are two conductive springs. A long flat spring is hinged at one end of the switch (the left, in the photograph) and has electrical contacts on the other.
Some switches may also be manufactured from other plastics like polyamide, polypropylene or pvc but mainly limited to wire mounted switches (like night lamp switches) mainly due to reduced weight, and most such switches are not used in high power devices (mainly table lamps, table fans, some radios) mainly up to 2 amperes.
A simple on-off switch. The two terminals are normally disconnected (open) and are closed when the switch is activated. An example is a pushbutton switch. SPST-NC Form B [4] Single pole, single throw, normally closed A simple on-off switch. The two terminals are normally connected together (closed) and are open when the switch is activated.
Pull switches may be either two-position (open or closed) or multi-position (allowing for different fan speeds or levels of illumination). Mounted inside a pull switch, there could be two types of two-position toggle switches. (In both cases the stable physical open- or closed -situation would be switch in outer and string in upper position.)
Normally closed mercury relay, with coil around top of tube and adjustable angle. A mercury relay (mercury displacement relay, mercury contactor) is a relay that uses mercury as the switching element. They are used as high-current switches or contactors, where contact erosion from constant cycling would be a problem for conventional relay contacts.
A push switch (button) is a momentary or non-latching switch which causes a temporary change in the state of an electrical circuit only while the switch is physically actuated. An automatic mechanism (i.e. a spring ) returns the switch to its default position immediately afterwards, restoring the initial circuit condition.