enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 19-inch rack - Wikipedia

   en.wikipedia.org/wiki/19-inch_rack

   DIN 41494-7 Dimensions of cabinets and suites of racks. DIN 41494-8 Components on front panels; mounting conditions, dimensions; DIN IEC 60297-3-100 (see above in IEC section) A rack's mounting fixture consists of two parallel metal strips (also referred to as posts or panel mounts) standing vertically. The posts are each 0.625 inches (15.88 mm ...

3. 32 mm cabinetmaking system - Wikipedia

   en.wikipedia.org/wiki/32_mm_cabinetmaking_system

   Distance of the holes in the row of holes: 32 mm; Diameter of the holes: 5 mm and 8 mm [clarification needed]. A typical 5 mm shelf stud may measure 15-16 mm long, and has a thin flange of about 7 mm diameter halfway at its length. Distance of the front row of holes to the front edge: 37 mm

4. Blocking (construction) - Wikipedia

   en.wikipedia.org/wiki/Blocking_(construction)

   Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.

5. Rack unit - Wikipedia

   en.wikipedia.org/wiki/Rack_unit

   Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...

6. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

7. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   The top and bottom plates are end-nailed to each stud with two nails at least 3 + 1 ⁄ 4 in (83 mm) in length (16d or 16-penny nails). Studs are at least doubled (creating posts) at openings, the jack stud being cut to receive the lintels (headers) that are placed and end-nailed through the outer studs. [10] Moisture barrier sheathing with ...