Ads
related to: 3.73 vs 3.55 for towing a trailer axle hub
Search results
Results from the WOW.Com Content Network
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and an "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.
There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
The Ford 8.8 is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1983 Ford trucks. The axle was developed to replace the Ford 9-inch axle. This axle is still in production today for a variety of Ford vehicles.
From 1999 to 2000, the rear axle ratio was 3.55:1, shortened to 3.73:1 in 2001. The same year, a 4.5-inch (110 mm) aluminum driveshaft replaced a 3.5-inch (89 mm) steel unit. [citation needed] Following the 2001 drivetrain revisions, Car and Driver magazine tested a Lightning, accelerating from 0–60 mph (97 km/h) in 5.2 seconds.
The live axle configuration offers advantages in off-road capability and performance at the expense of some on-road comfort and driveability. Mid-1985 and later two-wheel drive models used the same suspension and steering mechanisms with a single tube connecting axle ends, which also meant no transfer case, no front driveshaft, and no front ...
The TBR should not be confused with the uneven torque-split feature in the planetary-type Torsen III. The planetary gearset allows a Torsen III center differential to distribute torque unevenly between front and rear axles during normal (full traction) operation without inducing wind-up in the drivetrain.
Ads
related to: 3.73 vs 3.55 for towing a trailer axle hub