Search results
Results from the WOW.Com Content Network
It acts as an electronic toggle switch, the half bridge is not able to switch polarity of the voltage applied to the load. The half bridge is used in some switched-mode power supplies that use synchronous rectifiers and in switching amplifiers. The half-H bridge type is commonly abbreviated to "Half-H" to distinguish it from full ("Full-H") H ...
A DC-to-DC converter is an electronic circuit or electromechanical device that converts a source of direct current (DC) from one voltage level to another. It is a type of electric power converter . Power levels range from very low (small batteries) to very high (high-voltage power transmission).
Stand-alone switched-mode power supply An adjustable switched-mode power supply for laboratory use. A switched-mode power supply (SMPS), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently.
A DC to DC converter circuit that uses capacitors to store energy between stages. charge transfer switch A kind of charge pump circuit. charge-coupled device An imaging sensor or data storage device that represents a signal, or pixel, by the charge stored in a capacitor and is able to move that charge from one capacitor to the next. Chebyshev ...
A simple electric circuit made up of a voltage source and a resistor. Here, =, according to Ohm's law. An electrical network is an interconnection of electrical components (e.g., batteries, resistors, inductors, capacitors, switches, transistors) or a model of such an interconnection, consisting of electrical elements (e.g., voltage sources, current sources, resistances, inductances ...
A thyristor (/ θ aɪ ˈ r ɪ s t ər /, from a combination of Greek language θύρα, meaning "door" or "valve", and transistor [1]) is a solid-state semiconductor device which can be thought of as being a highly robust and switchable diode, allowing the passage of current in one direction but not the other, often under control of a gate electrode, that is used in high power applications ...
Push-pull converter (+12V → ±18V; 50W) as potted module. ① transformer; ② and ③ electrolytic capacitors vertical and horizontal mounted; ④ discrete circuit board in through-hole technology. A push–pull converter is a type of DC-to-DC converter, a switching converter that uses a transformer to change the voltage of a DC
Asymmetric bridge converter. The most common approach to powering an SRM is to use an asymmetric bridge converter. The switching frequency can be 10 times lower than for AC motors. [3] The phases in an asymmetric bridge converter correspond to the motor phases.