Ad
related to: electrical outlet height from floor in garage door bottom seal single track
Search results
Results from the WOW.Com Content Network
BS 546, Two-pole and earthing-pin plugs, socket-outlets and socket-outlet adaptors for AC (50–60 Hz) circuits up to 250 V is an older British Standard for three-pin AC power plugs and sockets: four sizes with current capacities from 2 A to 30 A. Originally published in April 1934, it was updated by a 1950 edition which is still current, [1 ...
A socket (also known as a receptacle or outlet) is fixed in place, often on the internal walls of buildings, and is connected to an AC electrical circuit. Inserting ("plugging in") the plug into the socket allows the device to draw power from this circuit.
A hinge on each side that attaches to the bottom of each side of the garage door. Using track hardware, a car can be parked much closer to the door, as the door is positioned entirely inside the garage door header when in the open position. Track-type hardware has less arc when raising and lowering the garage door than jamb-type hardware.
"A single switch may be used for the control of two socket-outlets located immediately adjacent to each other". (subject to the current rating of the switch to be at least equal to the (a) total current rating of the sockets concerned; or (b) the current rating of the overcurrent protection device concerned, whichever is the lesser value.) [ 19 ]
IEC 60906-1-plug. IEC 60906-1 (IEC designation "Type N") [1] is an international standard designed "to provide a standard for a safe, compact and practical 16 A 250 V AC system of plugs and socket-outlets that could be accepted by many countries as their national standard, even if not in the near future."
The single-phase colours of red phase and black neutral are replaced by brown phase and blue neutral. These colours have been used in appliance flexible cables since 1969. The cable core colours are described in IEC 60304 (1982-01), Standard colours for insulation for low- frequency cables and wires.
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
Leg as in "hot leg" refers to one of multiple hot conductors in an electrical system. The most common residential and small commercial service in Canada and the U.S., single split-phase, 240 V, features a neutral and two hot legs, 240 V to each other, and 120 V each to the neutral. The most common three-phase system will have three hot legs ...
Ad
related to: electrical outlet height from floor in garage door bottom seal single track