Search results
Results from the WOW.Com Content Network
Most manufacturers claim that overcharging is safe at very low currents, below 0.1 C (C/10) (where C is the current equivalent to the capacity of the battery divided by one hour). [23] The Panasonic NiMH charging manual warns that overcharging for long enough can damage a battery and suggests limiting the total charging time to 10–20 hours. [22]
The open-circuit voltage is 1.55 V, the average voltage during discharge is 1.25 V. [9] While the energy density is only around one third as that of a lithium battery, the distinctive virtue of the nickel–hydrogen battery is its long life: the cells handle more than 20,000 charge cycles [4] with 85% energy efficiency and 100% faradaic efficiency.
Panasonic's fourth-generation Eneloop batteries, in AA and AAA sizes Panasonic Eneloop Smart & Quick Charger BQ-CC55 Sanyo Eneloop battery charger. Eneloop (Japanese: エネループ, Hepburn: Enerūpu), stylized as eneloop, is a brand of 1.2-volt low self-discharge nickel–metal hydride (NiMH) rechargeable batteries and accessories developed by Sanyo [1] and introduced in 2005.
Primearth EV Energy Co., Ltd. (abbreviated as PEVE) is a Japanese manufacturer of prismatic nickel–metal hydride (NiMH) and lithium-ion battery packs for hybrid electric vehicles, located in Shizuoka Prefecture, Japan. PEVE's products had been solely based on NiMH until early 2011 when the company has started mass production of Li-ion battery ...
1.45–1.65 [5] 1.59 (442) [5] 6.02 (1,673) [5] 100 [5] 2.11 (474) [5] 60–70 [5] 0.17 [5] 3 [5] Mercury oxide–zinc: Mercuric oxide Mercury cell NaOH/ KOH Mercuric oxide: No 1942– [6] 1996 [7] 0.9 [8] 1.35 [8] 0.36–0.44 (99–123) [8] 1.1–1.8 (300–500) [8] 2 [6] Alkaline: Zn/ MnO 2 LR KOH Manganese (IV) oxide: No 1949 [9] 0.9 [10] 1. ...
Typically a battery is constant current charged at 1 CA rate until all the cells have reached at least 1.55 V. Another charge cycle follows at 0.1 CA rate, again until all cells have reached 1.55 V. The charge is finished with an equalizing or top-up charge, typically for not less than 4 hours at 0.1 CA rate.
The 1999 GM EV1 production vehicle, powered by nickel metal hydride batteries, had a 26.4 kWh battery and an EPA range of 105 miles. [9] [10] [note 1] The 2011 Nissan Leaf production vehicle had a 24 kWh battery and an EPA range of 84 miles. [11]
Nickel–zinc batteries have a charge–discharge curve similar to 1.2 V NiCd or NiMH cells, but with a higher 1.6 V nominal voltage. [5]Nickel–zinc batteries perform well in high-drain applications, and may have the potential to replace lead–acid batteries because of their higher energy-to-mass ratio and higher power-to-mass ratio – as little as 25% of the mass for the same power. [6]