Search results
Results from the WOW.Com Content Network
For longer span rafters, building materials manufacturers have created laminated veneer lumber (LVL) rafters that can be 2–5 times longer than typical wood rafter. In the US, most wood rafters have maximum length of 20 feet (6.1 m). [5] If a longer rafter is needed, LVL is an alternative.
Laminated veneer lumber (LVL) is an engineered wood product that uses multiple layers of thin wood assembled with adhesives. It is typically used for headers, beams, rimboard, and edge-forming material. LVL offers several advantages over typical milled lumber: Made in a factory under controlled specifications, it is stronger, straighter, and ...
Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°); Roman: the ridge height is 2 ⁄ 9 to 1 ⁄ 3 the span (an angle of 24° to 34°); Common: the rafter length is 3 ⁄ 4 the span (about 48°); Gothic: the rafters equal the span (60°); and
The purlins are the large beams perpendicular to the rafters; from this shot, it appears that there are three purlins on either side of the roof. The sheathing boards are sometimes called the roof deck and are painted white. A purlin (or historically purline, purloyne, purling, perling) is a longitudinal, horizontal, structural member in a roof.
This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof. Trusses usually occur at regular intervals, linked by longitudinal timbers such as purlins. The space between each truss is known ...
History. The reciprocal frame, also known as a Mandala roof, [1] has been used since the twelfth century in Chinese and Japanese architecture although little or no trace of these ancient methods remain. More recently they were used by architects Kazuhiro Ishii (the Spinning House) and Yasufumi Kijima, and engineer Yoishi Kan (Kijima Stonemason ...
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.