Search results
Results from the WOW.Com Content Network
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
The hardware fault injection method consists in real electrical signals injection into the DUT (devices under testing) in order to disturb it, supposedly well working, at hardware low level, and deceive the control - detection chain (if present) in order to see how and if the fault management strategy is implemented.
An alarm is a persistent indication of a fault that clears only when the triggering condition has been resolved. A current list of problems occurring on the network component is often kept in the form of an active alarm list such as is defined in RFC 3877, the Alarm MIB. A list of cleared faults is also maintained by most network management ...
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.
Locating faults in a cable system can be done either with the circuit de-energized, or in some cases, with the circuit under power. Fault location techniques can be broadly divided into terminal methods, which use voltages and currents measured at the ends of the cable, and tracer methods, which require inspection along the length of the cable.
The need to control software fault is one of the most rising challenges facing software industries today. Fault tolerance must be a key consideration in the early stage of software development. There exist different mechanisms for software fault tolerance, among which: Recovery blocks; N-version software; Self-checking software
A fault coverage test passes when at least a specified percentage of all possible faults can be detected. If it does not pass, at least three options are possible. First, the designer can augment or otherwise improve the vector set, perhaps by using a more effective automatic test pattern generation tool.
Failure analysis is the process of collecting and analyzing data to determine the cause of a failure, often with the goal of determining corrective actions or liability.. According to Bloch and Geitner, ”machinery failures reveal a reaction chain of cause and effect… usually a deficiency commonly referred to as the symptom…”