Search results
Results from the WOW.Com Content Network
It is available in diameters ranging from as small as 4" (10 cm) to as big as 18" (45 cm), but the most commonly used are even sizes ranging from 6" to 12" (15 to 30 cm). Flexible duct is very convenient for attaching supply air outlets to the rigid ductwork. It is commonly attached with long zip ties or metal band claps.
Flexible metallic conduit (FMC, informally called greenfield or flex) is made by the helical coiling of a self-interlocked ribbed strip of aluminum or steel, forming a hollow tube through which wires can be pulled. FMC is used primarily in dry areas where it would be impractical to install EMT or other non-flexible conduit, yet where metallic ...
A common cable installation technique for fiber cables remains cable pulling. After the duct is placed, a high-strength pull line is blown into the duct (if one has not already been pre-installed by the duct manufacturer). The pull line is attached to one end of the cable and is used to pull the cable through the duct.
A form of bus duct known as "plug-in bus" is used to distribute power down the length of a building; it is constructed to allow tap-off switches or motor controllers to be installed at designated places along the bus. The big advantage of this scheme is the ability to remove or add a branch circuit without removing voltage from the whole duct.
Very flexible power cables are used in automated machinery, robotics, and machine tools. See power cord and extension cable for further description of flexible power cables. Other types of flexible cable include twisted pair, extensible, coaxial, shielded, and communication cable. An X-ray cable is a special type of flexible high-voltage cable.
Typical installation tools (from lowest to highest price) are hand set, manual squeezer, pneumatic squeezer, kick press, impact riveter, and finally PLC-controlled robotics. The most common machine is the impact riveter and the most common use of semi-tubular rivets is in lighting, brakes, ladders, binders, HVAC duct-work, mechanical products ...
American Motors' chief stylist Dick Teague began work on the Pacer in 1971, anticipating an increase in demand for smaller vehicles throughout the decade. The new car was designed to offer the interior room and feel of a big vehicle that drivers of traditional domestic automobiles were accustomed to, but in a much smaller, aerodynamic, and purposefully distinctive exterior package. [13]
The installation position of the engines has also been optimised. Just as in the diesels, the petrol engines are now mounted with the exhaust side facing backwards and tilted at an angle of 12 degrees. The weight of these petrol engines made of die-cast aluminium is only 97 kg (214 lb) for the 1.2 TSI and 106 kg (234 lb) for the 1.4 TSI.