enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Knob-and-tube wiring - Wikipedia

   en.wikipedia.org/wiki/Knob-and-tube_wiring

   Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s.

3. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...

4. Mains electricity - Wikipedia

   en.wikipedia.org/wiki/Mains_electricity

   Minimum wire size for hand-held or portable equipment is usually restricted by the mechanical strength of the conductors. Many areas, such as the US, which use (nominally) 120 V, make use of three-wire, split-phase 240 V systems to supply large appliances. In this system a 240 V supply has a centre-tapped neutral to give two 120 V supplies ...

5. Hot tub - Wikipedia

   en.wikipedia.org/wiki/Hot_tub

   The earliest hot tubs were calderas in which hot stones were placed to heat the water. [citation needed] Therma in Ikaria has been a very popular place particularly for hydrotherapy ever since the 4th century B.C. [2] The remains of wrecked marble bathtubs along with a prehistoric aqueduct that have been unearthed from this area bear ample testimony of the place's popularity in the ancient times.

6. AC power plugs and sockets: British and related types

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets:...

   SANS 164-3 defines a 6 A plug and socket based on the BS 546 5 A. The South African Wiring Code now defines the plug and socket system defined in SANS 164-2 (IEC 60906-1) as the preferred standard, and it is expected that SANS 164-1 and SANS 164-3 devices will be phased out by around 2035. [96]

7. Residual-current device - Wikipedia

   en.wikipedia.org/wiki/Residual-current_device

   A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device, more specifically a form of Earth-leakage circuit breaker, that interrupts an electrical circuit when the current passing through line and neutral conductors of a circuit is not equal (the term residual relating to the imbalance), therefore ...

8. 220 Volt - Wikipedia

   en.wikipedia.org/wiki/220_Volt

   220 Volt is a common mains electricity voltage. It may also refer to: 220 Volt Live, a 1993 album by Tangerine Dream; 220 Volt (band), a Swedish heavy metal band ...

9. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   This three-wire single-phase system is common in North America for residential and light commercial applications. Circuit breaker panels typically have two live (hot) wires, and a neutral, connected at one point to the grounded center tap of a local transformer. Usually, one of the live wires is black and the other one red; the neutral wire is ...