Search results
Results from the WOW.Com Content Network
A conceptual diagram of a local area network using bus topology. A host on a bus network is called a station. In a bus network, every station will receive all network traffic, and the traffic generated by each station has equal transmission priority. [3] A bus network forms a single network segment and collision domain.
A fully connected network, complete topology, or full mesh topology is a network topology in which there is a direct link between all pairs of nodes. In a fully connected network with n nodes, there are () direct links. Networks designed with this topology are usually very expensive to set up, but provide a high degree of reliability due to the ...
Token Bus was standardized by IEEE standard 802.4. It was mainly used for industrial applications. Token Bus was used by General Motors for their Manufacturing Automation Protocol (MAP) standardization effort. [4] This differs from Token Ring networks in that the endpoints of the bus do not meet to form a physical ring.
The message traverses hops, and each hop's channel length depends on the topology. The topology significantly influences both latency and power consumption. Furthermore, since the topology determines the number of alternative paths between nodes, it affects the network traffic distribution, and hence the network bandwidth and performance ...
SPI lends itself to a "bus driver" software design. Software for attached devices is written to call a "bus driver" that handles the actual low-level SPI hardware. This permits the driver code for attached devices to port easily to other hardware or a bit-banging software implementation.
The implementation supports a connection-oriented transport protocol (Layer 4), a router-core (Layer 3), and several network-interfaces (Layer 1–2). A service-oriented topology eases the design of satellite subsystems, since the communication bus itself is the interface to other subsystems. This means that each subsystem developer only needs ...
Bus contention is an undesirable state in computer design where more than one device on a bus attempts to place values on it at the same time.. Bus contention is the kind of telecommunication contention that occurs when all communicating devices communicate directly with each other through a single shared channel, and contrasted with "network contention" that occurs when communicating devices ...
As there are only two endpoints on a tunnel, the tunnel is a point-to-point connection and PPP is a natural choice as a data link layer protocol between the virtual network interfaces. PPP can assign IP addresses to these virtual interfaces, and these IP addresses can be used, for example, to route between the networks on both sides of the tunnel.