Search results
Results from the WOW.Com Content Network
3Com 3C905B-TX 100BASE-TX PCI network interface card. 100BASE-TX is the predominant form of Fast Ethernet, and runs over two pairs of wire inside a Category 5 or above cable. Cable distance between nodes can be up to 100 metres (328 ft). One pair is used for each direction, providing full-duplex operation at 100 Mbit/s in each direction.
Ethernet is a shared medium, so that it is not guaranteed that only the two systems that are transferring a file between themselves will have exclusive access to the connection. If several systems are attempting to communicate simultaneously, the throughput between any pair can be substantially lower than the nominal bandwidth available.
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels.
For comparison, Ethernet's protocol efficiency when using maximum throughput frames with payload of 1500 bytes is up to 95% and up to 99% with 9000 byte jumbo frames. However due to Ethernet's protocol overhead and minimum payload size of 42 bytes, if small messages of one or a few bytes are to be sent, Ethernet's protocol efficiency drops much ...
It is a reactive measure employed in communication networks to regulate network traffic and minimize bandwidth congestion. Bandwidth throttling can occur at different locations on the network. On a local area network , a system administrator ("sysadmin") may employ bandwidth throttling to help limit network congestion and server crashes. On a ...
Through the first half of the 1980s, Ethernet's 10BASE5 implementation used a coaxial cable 0.375 inches (9.5 mm) in diameter, later called thick Ethernet or thicknet. Its successor, 10BASE2, called thin Ethernet or thinnet, used the RG-58 coaxial cable. The emphasis was on making installation of the cable easier and less costly.
Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only ...