enow.com Web Search

  1. Ads

    related to: honda 250es front axle parts 1990s dodge truck

Search results

  1. Results from the WOW.Com Content Network
  2. Dana 44 - Wikipedia

    en.wikipedia.org/wiki/Dana_44

    The Dana 44 Front axle first saw use in the 1950s and still in use today. Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks.

  3. Dana 70 - Wikipedia

    en.wikipedia.org/wiki/Dana_70

    Both companies used Dana 70 front axles until the mid-1970s (Dodge W300 pickup up until 1978, discontinued in 1979). All of these Dana 70 front axles were closed knuckle, with king pins and had a GAWR of 6000 lbs. Like the rear Dana 70 axles, the Dana 70 front axle started out with 23 spline axle shafts and then went to 35 spline axle shafts.

  4. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    Front axle. International Harvester. 1975 1300 Camper Special ← A Dana BOM number series was created but no record of any Dana 60 front axles being used by International has been proven. Chevrolet 1977–1991 1Ton (K30/V30) 1984–1988 Commercial Utility Cargo Vehicle; 2019–2020 Medium Duty; Dodge 1975–2002 3 ⁄ 4-ton (D-600/W-250/2500)

  5. Saginaw 9.5-inch axle - Wikipedia

    en.wikipedia.org/wiki/Saginaw_9.5-inch_axle

    The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.

  6. Ram pickup - Wikipedia

    en.wikipedia.org/wiki/Ram_pickup

    The Dodge Ram features a wide variety of axles. For the front axle of 4×4 Rams, a Dana 44 was used on all 1500s and the early (light-duty) 2500s. However, most of the 2500 and all 3500 Rams use Dana 60 front axles. The 1500s and some early light-duty 2500s used a 9.25 Chrysler (Spicer) axle in the rear.

  7. Dana 80 - Wikipedia

    en.wikipedia.org/wiki/Dana_80

    Trac Loks were a US$350.00 option with Ford Super Duty trucks. [1] The Dana 80 Trac Lok is unique being it is a 4 pinion unit, unlike other Dana Trac Lok units with 2 pinions. This was the only rear axle available for the 2nd generation Dodge Ram 3500 trucks. [2] 35 Spline Dana 80 in a 2002 Dodge 2500HD Diesel

  1. Ads

    related to: honda 250es front axle parts 1990s dodge truck