Search results
Results from the WOW.Com Content Network
The P&D connector shares the 30-pin plus quad-coax layout of EVC, which carries digital video, analog video, and data over Universal Serial Bus (USB) and IEEE 1394 (FireWire). At a minimum, the P&D connector is required to carry digital video, in which case the connector is designated P&D-D ; when both digital and analog video are included, the ...
The Video Graphics Array (VGA) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [ 1 ] as well as many monitors, projectors and HD television sets.
35-pin MicroCross Molex connector VESA Enhanced Video Connector and VESA Plug and Display (a.k.a. M1-DA) both used this connector with slightly different pin assignments. These schemes combined VGA or digital video, audio, FireWire, and USB signals into a single connector. Deprecated. Made obsolete by DFP and later DVI. HDI-45: Apple proprietary.
PAL connector, common in Europe as an antenna connector; S-Video (1 Mini-DIN) SDI - Broadcast grade digital interface over BNC cables; VGA connector A type of D-sub connector standard on most video cards; Mini-VGA Found on some laptop computers; 5 BNC Connectors can also be used to carry the VGA signal as R, G, B, HSync, VSync
Video in video out (usually seen as the acronym VIVO), commonly pronounced (/ ˈ v i. v oʊ / VEE-voh), is a graphics port which enables some video cards to have bidirectional (input and output) analog video transfer through a mini-DIN connector, usually of the 9-pin variety, and a specialised splitter cable (which can sometimes also transfer analog audio).
The VESA Enhanced Video Connector (EVC) is a VESA standard that was intended to reduce the number of cables around a computer by incorporating video, audio, FireWire and USB into a single cable system, terminating in a 35-pin Molex MicroCross connector. The intent was to make the monitor the central point of connection.
The standard supports the simultaneous transfer of data (at least USB 2.0, and depending on video resolution: USB 3.1 Gen 1 or 2) and power charging (up to 40 W via USB Power Delivery), in addition to MHL audio/video. [2] This allows the connection to be used with mobile docks, allowing devices to connect to other peripherals while charging ...
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...