Ads
related to: rockwell knife steel chart
Search results
Results from the WOW.Com Content Network
Very hard steel (e.g. chisels, quality knife blades): HRC 55–66 (Hardened High Speed Carbon and Tool Steels such as M2, W2, O1, CPM-M4, and D2, as well as many of the newer powder metallurgy Stainless Steels such as CPM-S30V, CPM-154, ZDP-189. There are alloys that hold a HRC upwards 68-70, such as the Hitachi developed HAP72.
A variety of hardness-testing methods are available, including the Vickers, Brinell, Rockwell, Meyer and Leeb tests. Although it is impossible in many cases to give an exact conversion, it is possible to give an approximate material-specific comparison table for steels.
The 10xx series is the most popular choice for carbon steel used in knives as well as katanas. They can take and keep a very sharp edge. [59] 1095, a popular high-carbon steel for knives; it is harder but more brittle than lower-carbon steels such as 1055, 1060, 1070, and 1080.
The addition of cobalt increases heat resistance, and can give a hardness up to 70 Rockwell C. [14] M35 M35 is similar to M2, but with 5% cobalt added. M35 is also known as Cobalt Steel, HSSE or HSS-E. It will cut faster and last longer than M2. [15] M42 M42 is a molybdenum-series high-speed steel alloy with an additional 8% cobalt. [14]
Type 440—a higher grade of cutlery steel, with more carbon, allowing for much better edge retention when properly heat-treated. It can be hardened to approximately Rockwell 58 hardness, making it one of the hardest stainless steels. Due to its toughness and relatively low cost, most display-only and replica swords or knives are made of 440 ...
In 2009, Crucible Steel introduced an update to CPM-S30V to meet the needs of renowned knife maker Chris Reeve that they called CPM-S35VN. The addition of 0.5% Niobium, and reductions in both Carbon (from 1.45% to 1.40%) and Vanadium (from 4% to 3%) produced an alloy with 25% increase in measured Charpy V-notch toughness over S30V (Crucible claims 15-20% improvement).
Permit class USS Plunger on the building ways at Mare Island. HY-80 is a high-tensile, high yield strength, low alloy steel.It was developed for use in naval applications, specifically the development of pressure hulls for the US nuclear submarine program and is still currently used in many naval applications.
440C (UNS designation S44004) is a martensitic 400 series stainless steel, [1] and has the highest carbon content of the 400 stainless steel series. It can be heat treated to reach hardness of 58 to 60 HRC. It can be used to make rolling contact stainless bearings, e.g. ball bearings and roller bearings. It is also used to make knife blades.
Ads
related to: rockwell knife steel chart