Search results
Results from the WOW.Com Content Network
The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).
A ball bearing. A bearing is a machine element that constrains relative motion to only the desired motion and reduces friction between moving parts.The design of the bearing may, for example, provide for free linear movement of the moving part or for free rotation around a fixed axis; or, it may prevent a motion by controlling the vectors of normal forces that bear on the moving parts.
A cross-bolted bearing is a bearing, usually a crankshaft main bearing of a piston engine, reinforced with additional transverse bolts.Most bearing caps are retained by two bolts, one on each side of the bearing journal, and parallel to the cylinder axis (or, on vee engines, parallel to an axis bisecting the vee angle).
Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942 The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3]
The structural lower part of a vehicle to which the running gear and body are attached, [1] or more generally the main load-bearing framework which supports all of a vehicle's mechanical parts and other components and on which the body is mounted. [3] Compare rolling chassis. choke. Also choke valve or strangler.
This setup allows the axle shaft to be the means of propulsion, and also support the weight of the vehicle. The main difference between the full- and semi-floating axle setups is the number of bearings. The semi-floating axle features only one bearing, while the full-floating assembly has bearings on both the inside and outside of the wheel hub.
A cleaning company has been fined $171,000 after federal investigators found 11 children working a "dangerous" overnight shift at a meat processing plant in Iowa.
Typical design of automobile engine connecting rod Typical aluminium rod (left), oil drip rod (centre), steel rod (right). A connecting rod, also called a 'con rod', [1] [2] [3] is the part of a piston engine which connects the piston to the crankshaft.