enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dual flush toilet - Wikipedia

   en.wikipedia.org/wiki/Dual_flush_toilet

   There are also dual-flush toilets that use a siphon valve operated by a lever rather than buttons, with a ≤ 6L full flush, and a ≤ 3L half-flush if the flush handle is held down [8] or released immediately after flushing. [9] Tipping bucket. The tipping bucket cistern can operate in a dual flush mode when the lever is rotated halfway 2.5/5 ...

3. Ballcock - Wikipedia

   en.wikipedia.org/wiki/Ballcock

   When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water, which will exit to the toilet bowl below, so that the tank may empty.

4. Sloan Valve Company - Wikipedia

   en.wikipedia.org/wiki/Sloan_Valve_Company

   The company was founded by William Elvis Sloan in Chicago, Illinois in 1906 with the introduction of the Royal flushometer, a valve to release a measured amount of water to flush a urinal or toilet. Initial sales were very poor: only a single Royal model flushometer was sold in 1906, and two in 1907.

5. Flushometer - Wikipedia

   en.wikipedia.org/wiki/Flushometer

   A narrow passageway leads from the main water supply into the pressure chamber. It is the narrowness of this passage that meters the flow by slowing repressurizing of the pressure chamber after the action of a flush. The diaphragm technology allows the flush valve to open and let water into the bowl. A main cylinder valve operates up and down.

6. Flush toilet - Wikipedia

   en.wikipedia.org/wiki/Flush_toilet

   The larger flapper-flush valve is used on toilets that use less water, such as 1.6 US gal (6.1 L) per flush. Some have a bell inlet for a faster more effective flush. A problem with the valve type flush mechanism is that it invariably starts to leak after a couple of years use due to wear and tear of the valve, particles, etc. trapped in the valve.

7. Downhole safety valve - Wikipedia

   en.wikipedia.org/wiki/Downhole_safety_valve

   This movement compresses a large spring and pushes the flapper downwards to open the valve. When hydraulic pressure is removed, the spring pushes the sleeve back up and causes the flapper to shut. In this way, it is failsafe and will isolate the wellbore in the event of a loss of the wellhead .