Search results
Results from the WOW.Com Content Network
Packet Tracer is a free network simulator tool for certification exam preparation, particularly for CCNA students. It’s available directly through the Cisco Networking Academy. Download and install the Packet Tracer software by signing up for the Introduction to Packet Tracer course, which teaches you the basics of using the tool. Download ...
All ports that are not assigned to a VLAN should be disabled. S1(config)#interface range f0/1-5,g0/2. S1(config-if-range)#shutdown. Configure inter-VLAN routing on R1 based on the Addressing Table. Verify connectivity. R1, S1, and all PCs should be able to ping each other and the server.
However, Cisco Packet Tracer has some significant advantages for CCNAs: · Cost: Free. · Low CPU & RAM: It should run on the computer you already own as a desktop app. · Usefulness for CCNA: Supports 90%+ of the CCNA config/verify topics. · Quality: Excellent for its intended purpose as a learning tool.
Knowledge. Desde el mes de febrero del 2021 el software de simulación de redes "Cisco Packet Tracer", ha sido actualizado a la versión 8 (para ser exacto la versión 8.0.0.0212). Aunque a la fecha de este artículo ya estamos en el año 2023 con la versión 8.2 (para ser exacto la versión 8.2.1.0118), este software tiene novedades ...
Step 1: Configure both PCs with IP addresses. a. Click PC1, and then click the Desktop tab. b. Click IP Configuration. In the Addressing Table above, you can see that the IP address for PC1 is 192.168.1.1 and the subnet mask is 255.255.255.0. Enter this information for PC1 in the IP Configuration window. c. Repeat steps 1a and 1b for PC2.
Packet tracer official download link is at NetCad: you must be logged into netcad.com first, open a new tab and copy the following links for the target OS: (Windows Desktop Application 64-bit Packet Tracer Ver 8.2.1)
Step 2: Observe traffic flow in the network. a. Click the Simulation mode button in the lower right-hand corner of the PT window to switch from Realtime to Simulation mode. b. Open the Command Prompt for Sales 2, and then enter the ping command followed by the IP address of Sales 1. c. Use the Capture then Forward button (the triangle pointing ...
Step 2: Create a DHCP pool on R2 for the R1 LAN. a. Create a DHCP pool named R1-LAN. The pool name must match this value in order for you to get credit for your configuration. b. Configure the DHCP pool to include the network address, the default gateway, and the IP address of the DNS server. R2(config)#ip dhcp pool R1-LAN.
Step 3: Observe the network behavior when R3 becomes unavailable. a. Select the delete tool from the Packet Tracer tool bar and delete the link between R3 and S3. b. Open a command prompt on PC-B. Execute the tracert command with the Web Server as the destination. c. Compare the current output with the output of the command from Step 2.
Part 1: Configure Layer 3 Switching. In Part 1, you will configure the GigabitEthernet 0/2 port on switch MLS as a routed port and verify that you can ping another Layer 3 address. a. On MLS, configure G0/2 as a routed port and assign an IP address according to the Addressing Table. MLS(config)# interface g0/2.