Search results
Results from the WOW.Com Content Network
An API oil–water separator is a device designed to separate gross amounts of oil and suspended solids from industrial wastewater produced at oil refineries, petrochemical plants, chemical plants, natural gas processing plants and other industrial oily water sources.
A heated-water bath is probably the most effective method of removing foam bubbles from foaming crude oil. A heated-water bath is not practical in most oil and gas separators, but heat can be added to the oil by direct or indirect fired heaters and/or heat exchangers, or heated free-water knockouts or emulsion treaters can be used to obtain a ...
An oil tanker's inert gas system is one of the most important parts of its design. [18] Fuel oil itself is very difficult to ignite, however its hydrocarbon vapors are explosive when mixed with air in certain concentrations. [19] The purpose of the system is to create an atmosphere inside tanks in which the hydrocarbon oil vapors cannot burn. [18]
Downhole oil–water separation (DOWS) technology is an emerging technology that separates oil and gas from produced water at the bottom of the well, and re-injects most of the produced water into another formation which is usually deeper than the producing formation, while the oil and gas rich stream is pumped to the surface.
Marine Oily water separator. A gravity plate separator contains a series of oleophilic plates through which the contaminated water flows. The oil in the water coalesces on the underside of the plate eventually forming droplets before coalescing into liquid oil which floats off the plates and accumulates at the top of the chamber.
An alternative to this type of coalescer is a flow through pre-coalescer that is installed upstream in a separator tank. In the Compact Electrostatic Coalescer, [2] droplet coalescence is achieved by applying AC electric fields (50–60 Hz) to water-in-oil emulsions under turbulent-flow conditions. The turbulence increases the collision ...
In a centrifugal oil and water separator, the force of gravity is one-thousand [citation needed] times greater that of the coalescing plate pack separator or the petrol interceptor, so the separation is much greater. Not only is the force of separation greater, but there are fewer working parts so maintenance is much easier and cheaper.
With a 3 phase decanter centrifuge, it is possible to separate 3 phases from each other in one process step only. For example, two liquids which cannot be mixed because of different densities (e.g. oil and water) are separated from a solids phase. The heavy liquid (water) collects in the middle between the oil and the solids layer.