Search results
Results from the WOW.Com Content Network
Pulsed Nd:YAG lasers are typically operated in the so-called Q-switching mode: An optical switch is inserted in the laser cavity waiting for a maximum population inversion in the neodymium ions before it opens. Then the light wave can run through the cavity, depopulating the excited laser medium at maximum population inversion.
The first laser, invented by Theodore Maiman in May 1960. Nd:YAG laser: 1.064 μm, (1.32 μm) Flashlamp, laser diode: Material processing, rangefinding, laser target designation, surgery, tattoo removal, hair removal, research, pumping other lasers (combined with frequency doubling to produce a green 532 nm beam). One of the most common high ...
Q-switching, sometimes known as giant pulse formation or Q-spoiling, [1] is a technique by which a laser can be made to produce a pulsed output beam. The technique allows the production of light pulses with extremely high peak power, much higher than would be produced by the same laser if it were operating in a continuous wave (constant output) mode.
Such a laser is said to be "mode-locked" or "phase-locked". These pulses occur separated in time by τ = 2L/c, where τ is the time taken for the light to make exactly one round trip of the laser cavity. This time corresponds to a frequency exactly equal to the mode spacing of the laser, Δν = 1/τ. The duration of each pulse of light is ...
The most basic optical tweezer setup will likely include the following components: a laser (usually Nd:YAG), a beam expander, some optics used to steer the beam location in the sample plane, a microscope objective and condenser to create the trap in the sample plane, a position detector (e.g. quadrant photodiode) to measure beam displacements ...
Pulsed Nd:YAG and Er:YAG lasers are used in laser tattoo removal and laser range finders among other applications. Pulsed lasers are also used in soft-tissue surgery. When a laser beam comes into contact with soft-tissue, one important factor is to not overheat surrounding tissue, so necrosis can be prevented. [3]
Photodisruption is a form of minimally invasive surgery used in ophthalmology, utilizing infrared Nd:YAG lasers to form plasma ("lightning bolt"), which then causes acoustic shock waves ("thunderclap") which then in turn affects tissue.
A flash lamp pumped Nd:YAG laser normally has a pulse duration on the order of hundreds of microseconds to a millisecond, peak power in the order of sub MW/cm 2, and material removal rate of ten to hundreds of micrometers per pulse. For machining processes by each laser, ablation and melt expulsion typically coexist. [citation needed]