Search results
Results from the WOW.Com Content Network
An agitator is composed of a drive device ( motor, gear reducer, belts…), a guiding system of the shaft (lantern fitted with bearings), a shaft and impellers . If the operating conditions are under high pressure or high temperature, the agitator must be equipped with a sealing system to keep tightened the inside of the tank when the shaft is ...
The Home Depot Pro, headquartered in Jacksonville, ... was acquired in October 2010 for $60.1 million. [20] CleanSource was founded in 1956 in San Jose, California.
There are many stroker kits available for RB engines (some only available as proper kits while others being achievable by using cranks from other engines, for example a GT-R crank, pistons and rods in an RB25DET will make its displacement 2.6L as the bore is the same as an RB26DETT). Achievable stroker displacements for RB engines: RB20 - 2.2, 2.4
Police in Illinois say they are investigating a shooting that left two adults, two children and three dogs dead. Officers were called to a home on Sunday, Sept. 17 around 8:45 p.m. to perform a ...
The Dual-action is a two-part agitator that has bottom washer fins that move back and forth and a spiral top that rotates clockwise to help guide the clothes to the bottom washer fins. The modern agitator, which is dual-action, was first made in Kenmore Appliances washing machines in the 1980s to present. These agitators are known by the ...
In 1998, the 11.1-liter Detroit Diesel Series 60 was discontinued. [5] Once the 11.1-liter Series 60 was discontinued, the 12.7-liter Detroit Diesel Series 60 became the motorcoach application. Starting in the late 1990s, Neoplan made the Series 60 as an available engine for their high-floor and low-floor articulated buses - the AN460A and ...
People in the Sacramento area might think they own a Sears house. Here’s why these houses are often confused.
A critical element in vane motor design is how the vane tips are machined at the contact point between vane tip and motor housing. Several types of "lip" designs are used, and the main objective is to provide a tight seal between the inside of the motor housing and the vane, and at the same time to minimize wear and metal-to-metal contact.